Planning mortar-joint preparation safely

A preparation checklist covering trial areas, masonry damage, dust controls and recording the cavity for estimation.

Pointing Calculator • • 2 min read

Removing existing mortar changes the masonry as well as the quantity of new mortar required. Before work starts, establish which joints need repair and which should remain. Movement, loose units or persistent water entry need investigation rather than being covered by fresh pointing.

Agree a trial area

Use an accessible sample to establish the repair depth, finish and suitable tools with a competent mason or conservation adviser where appropriate. Hard existing mortar and fragile brick or stone edges make tool choice particularly important. Stop and review the method if unit edges are being cut or loosened.

The NPS repointing brief gives context for historic masonry preparation. It should not be reduced to one universal depth or one tool recommendation.

Plan dust and access controls

Cutting and grinding masonry can create hazardous dust. Follow a task-specific assessment and the equipment manufacturer’s instructions. HSE guidance prioritizes reducing dust generation and controlling it at source, with suitable respiratory protection where required. Work at height also needs properly planned access.

Review HSE construction-dust guidance before selecting the work method. This quantity website does not assess a particular site’s exposure or prescribe protective equipment.

Measure the prepared cavity

After the trial area is prepared and loose material addressed according to the specification, measure the actual width and fill depth at several points. Record unexpected deep pockets separately. Inspect the remaining unit edges and sound backing before estimating the rest of the elevation.

Use the measurement guide to record net area or joint length. Recalculate when preparation reveals a different depth. Keep the survey, photographs and approved trial-area details with the order so the estimate reflects the work actually agreed.

Ready to estimate your repointing project?

Estimate joint volume, product packs and a stated waste allowance from measured inputs.

Calculator