Measuring joint length in irregular stone walls
Survey stonework by tracing joint runs, separating width and depth groups, and checking a sample area.
A repeating brick module is a poor description of rubble stonework. Large and small stones create an irregular network of joints. Use total-joint-length mode when you can measure that network more reliably than you can assume a standard unit size.
Survey each joint once
Work from a scaled drawing, a suitably scaled photograph or accessible measurements on the wall. Mark traced runs as you count them so shared boundaries are not added twice. Separate long horizontal runs from branching joints and check that your survey covers the whole repair area.
Measure width and prepared fill depth at representative positions. Group narrow, medium and wide joints when their dimensions differ substantially. One arithmetic average can hide the extra volume in wide or deep pockets.
A two-group example
Suppose one group totals 40 m with a 15 mm width and 25 mm depth:
40 × 0.015 × 0.025 × 1000 = 15 L
A second group totals 20 m with a 25 mm width and 30 mm depth:
20 × 0.025 × 0.030 × 1000 = 15 L
Calculate each group separately, then add the base volumes: 30 L. An illustrative 15% allowance makes 34.5 L. Add waste once, not again after summing results that already include it.
Check irregular intersections
The length method treats joints as rectangular prisms. At wide branching intersections, traced centre lines may overlap; measure these junctions separately or check the estimate against a representative trial area. Hidden voids and backing repairs also need a separate allowance or specification.
Use the calculator in total-joint-length mode. Keep a sketch showing measured runs, dimension groups and excluded areas with the estimate.
Ready to estimate your repointing project?
Estimate joint volume, product packs and a stated waste allowance from measured inputs.