Estimating mortar for 215 × 65 mm brickwork

A worked 10 m² brickwork example, including openings, joint width, fill depth, waste and product yield.

Pointing Calculator • • 2 min read

A brickwork estimate starts with the face of the wall that needs repointing. It does not include the mortar hidden throughout the full wall thickness. Measure the brick faces and several joints before accepting the calculator’s metric-brick preset.

Record the actual work area

A wall 5 m long and 2.4 m high has an area of 12 m². Deduct a 1 m × 2 m opening to obtain 10 m². Include reveals or a second wall face only when they also need work; measure these separately. For patch repairs, enter only the affected area.

Calculate the joint volume

For 215 × 65 mm brick faces and uniform 10 mm joints, the repeating module is 225 × 75 mm. Its joint-face fraction is:

1 − (215 × 65) / (225 × 75) = 0.17185185

At a measured fill depth of 20 mm, the base volume is:

10 m² × 0.17185185 × 0.020 m × 1000 = 34.37037 L

This model counts joint intersections once. It assumes repeating rectangular units and constant depth. Small wall boundaries, decorative bonds, worn faces and deep pockets introduce differences from the ideal pattern.

Add purchasing assumptions

An illustrative 10% allowance gives 37.80741 L. If the chosen complete mortar product yields 14 L per pack, divide by 14 and round up: three packs. The 14 L figure is an example, so replace it with the supplier’s declared yield. A bag of binder alone is not a pack of complete mortar.

Enter these dimensions in the calculator, then compare its assumptions with a representative prepared test area. The methodology explains the geometric model. Investigate damaged bricks, movement or damp before treating a quantity estimate as a repair specification.

Ready to estimate your repointing project?

Estimate joint volume, product packs and a stated waste allowance from measured inputs.

Calculator